Re: Perl in xtable

[Fritz Zaucker <nospam@thanx>]

Carsten Frewert <frewi@uni-paderborn.de> writes:

I assume that <xtable> is itself defined in Perl. No perl-tag can use
Perl inside as ePerl does not support nesting at this point.

Fritz

> I can't use any Perl statements inside a <xtable> </xtable>.
> 
> wml exits with the following message:
> 
> > ePerl:Error: Perl parsing error (interpreter rc=2)
> >
> > ---- Contents of STDERR channel: ---------
> > Can't find string terminator "__XTABLE__EOT" anywhere before EOF at
> > /tmp/wml.11585.tmp1 line 541.
> > ------------------------------------------
> > ** WML:Break: Error in Pass 3 (rc=74).
> 
> The same perl-code outside the xtable runs fine.
> 
> Can someone reproduce this behaviour?
> 
> Oops, I'm using wml 1.6.8 with perl 5.004_04

-- 
Dr. Fritz Zaucker, Head IT Support Group
Department of Electrical Engineering,  Federal Institute of Technology
ETZ J97, Gloriastrasse 35, 8092 Zurich, Switzerland
Tel.: +41-1-632-5241 Fax: +41-1-632-1194 http://ee-staff.ethz.ch/~zaucker/
E-mail: zaucker@ee.ethz.ch (see home page for PGP key)
______________________________________________________________________
Website META Language (WML)                www.engelschall.com/sw/wml/
Official Support Mailing List                   sw-wml@engelschall.com
Automated List Manager                       majordomo@engelschall.com