how to apply patch-SNAP to wml-1.6.8?

[Viorel ANGHEL <nospam@thanx>]

After a long pause, i'm again interested in wml. I've downloaded
the stable version, compiled, everithing went ok.

Now, for the patch, should i run that shell script in the
directory created by wml...tar.gz after tar-gunzip? I suppose
yes. After or before configure? 

For short, is this procedure ok:

get clean source -> configure -> make -> make test -> make clean
-> run patch_script in the same directory as configure -> make
-> make install

I understand that the patch is intended only for developers, so
if you'll ignore my question i won't be mad ;-)



        ___
       <o-o>    Viorel ANGHEL <vang@altavista.net>
       [`-']    
       -"-"-    It's great to be smart 'cause then you know stuff.
______________________________________________________________________
Website META Language (WML)                www.engelschall.com/sw/wml/
Official Support Mailing List                   sw-wml@engelschall.com
Automated List Manager                       majordomo@engelschall.com